How To Clean Upholstery And Carpets

There are many different ways which you can take when approaching a carpet and upholstery cleaning task. The reason you are cleaning (general clean, removal of stains etc) as well as the kind of fabric you are cleaning both determine the kind of method you will choose. Whether you are going to use a professional carpet cleaning service or you are planning on doing it yourself, here are some basic guidelines to follow to make sure you don’t damage the material.

Methods of cleaning carpets

Other than the countless ‘housewives remedies’, there are generally five recognized methods of cleaning carpets. Steam (also known as hot water extraction), shampoo, bonnet or quick dry and dry absorbent compound cleaning.

Steam cleaning (a.k.a hot water extraction) is probably the most popular of all the different methods but not always the best since the drying time, depending on the material, can be as long as 12 hours. A high-powered pump sprays a cleaning fluid into the carpet which is then sucked out immediately by a strong vacuum.

Any appliance store can offer you a wide variety of carpet cleaning machines. Many of these appliances are upright, free standing units with a solution tank for the cleaning fluid and two or three nylon brushes on the underside. The procedure is the automated version of somebody cleaning with a scrubbing brush in that the dirt is loosened by the brushes and then the dirt and dust is then vacuumed (normally with a separate vacuum cleaner) afterwards. As with steam cleaning, the carpet takes about 12 hours to dry.

Cleaning using the quick dry method may actually seem to be the same as carpet shampooing but the machine is slightly different in that, instead of brushes, it uses a couple of absorbent pads. A quick dry cleaning detergent is first spread over the carpet and then the machine buffs the carpet clean by absorbing the detergent as well as the dirt. The process is similar to buffing your tiled floors. It takes about an hour to dry so this method is ideal for high traffic areas.

If you are looking for a method that is between steam cleaning and shampooing then dry foam cleaning is the answer. Foam is distributed over the carpet using a machine which has rolling brushes after which the carpet is sucked clean using the standard carpet vacuum cleaner. It only takes an hour or two to dry.

Dry absorbent compound is a powder which contains solvents and detergents, which are spread lightly on the carpet. You, or the professional you hire, uses a machine which scrubs the mixture into the carpet fibers and the carpet is left to stand for a bit. After a little wait, the vacuum cleaner is then used to suck up the compound (which has by now absorbed all the dirt) as a result the carpet stays as dry as it was when you started. This is probably the best method to use if you have thick carpets which can go moldy underneath if they stay wet for too long.

How to clean upholstery

The upholstery fabric is what normally determines what kind of cleaning method will be used. Velvets and silks, for example, can only be dry cleaned and, unless you really know what you are doing, is best left to an upholstery cleaning professional. Other more durable fabrics can be steam cleaned similar to carpets as they do not suffer any side effects from getting wet. The hot extraction method (steam cleaning) is identical to that which is used for carpets except that the nozzle is a small, hand held version. Hand shampooing can also be used but instead of using a machine the cleaning fluid is agitated into a foam and this foam is then applied to the fabric using a sponge.

Identifying the upholstery material

Many people are unaware of the best method to choose when cleaning furniture. In many cases you should find a label (possibly on the underside of one of the cushions) which will state the manufactures instructions, suggestions and warning. The most important thing to look out for is the code, either right at the top or right at the bottom of the label with either a ‘S’, ‘W’ or ‘SW’. ‘S’ indicates that the fabric should be dry cleaned while wet cleaning is indicated with the ‘W’. Materials which can be both wet and dry cleaned are indicated by the ‘SW

Industrial carpet cleaners and daily office cleaning contracts all welcome. References provided. www.crystalcleansolutions.co.uk Don’t reprint this exact article. Instead, reprint a free unique content version of this same article.